Set for 4 Footstrap Anti Twist S4LT

Anti twist washers for 4 footstraps S4LT model ATW 277
 Universal - easy to install on all most every windsurf  or of wingfoil board  

In the package:

• 8 pcs of bottom washers, top plates and blocking screws (6 mm) for 4 footstraps
• Color black

To install the foot strap plates, you need:

• the original foot strap screws supplied with your board/foot straps
• a correct PH3 or TX screwdriver (depending on the delivered screws)
• a foot strap with three holes at each foot strap position
• per foot strap, 2 bottom plates, two top plates, and two TX30 screws

Step by step assembly plan

1. Remove the foot straps from the board and any plastic plates present on the foot strap.
2. Place the base plate on the board, with the center of the base plate at the position where you want to mount the foot strap (step A in the image).
3. Determine which foot strap plug the supplied screw should be mounted into so that it fits into the recess of the base plate (step B in the image to the right). Screw the screw into the board at the chosen position until it touches the footpad. With thick/soft footpads, it may press slightly into the footpad. The TX30 screw can be mounted on either side (see position B or G) of the base plate or at an angle, for example for the front foot straps.
4. Take the base plate and push the two upright pins through the outer holes in the foot strap (step C), press the top plate onto the pins protruding from the top (as shown in step D).
5. Using the original foot strap screw, screw it through the top plate, foot strap and bottom plate so that it protrudes slightly from the bottom of the foot strap (step E)
6. Now mount the foot strap with the foot strap screw at the position chosen in step 2 (A). When tightening the foot strap, the base plate is pressed onto the deck pad and the TX 30 screw must fit into the recess of the base plate. When tightening, make sure that the screw is properly seated in the recess. With thicker pads, the bottom plate may have to be pressed into the deck pad to fit properly with the screw (see step F).
7. Mount the other side of the foot strap in the same way. It is not necessary to tighten the foot strap screws with excessive force; tight is tight. The TX30 screw prevents the foot strap from rotating.

Points of attention::

• On newer Fanatic/Duotone slalom board models, the footstrap plugs for the rear straps are not aligned; instead, they are offset at a 22.5-degree angle. As a result, the S4LT anti-twist plates may not fit the board perfectly, and you might need to make some adjustments. This is certainly doable, but it requires some practical skill and the use of tools such as a Dremel, a drill, or a round file.
• On some wave and freestyle boards, the inner holes for the two front footstraps are positioned so close together that the straps overlap right out of the factory, which can sometimes make fitting them a bit tricky.
• Footstrap screws are not included with the anti-twist plates; please use the screws that came with your board, or alternatively, order our Torx footstrap screws separately.

Should the anti-twist plates not fit properly, you are always welcome to return them, provided they remain undamaged!